WANTED!!! crf50 frame

[Pinelli_7]

hey guys, i was just wondering if anyone would have a crf50 frame that they would sell to me seeing as my 50 is pretty much like a chopper!! hahaha thanx

[Ry_Nos]

Have you tried fixing it?

Its simple and cheap.

Cut it from underneath using a 1mm angle grinder blade. Dont cut it all the way through. Once cut close the gap and tack it.

Once youve got it right weld up the cut using a stick welder with low hydrogen rods.

Then lay some 25 x 25 x 3 mm angle along the frame and weld up again using the low hydrogen rods.

Mine has been like this for ages and hasnt moved a mm

[Pinelli_7]

thanx Ry Nos i will give it a go

[Ry_Nos]

You might need to make a few cuts to get it right

They always bent at the kink left in the steel tube from the tube bender.

Use the low hydrogen rods otherwise the welds might snap

They have a glass like flux left after welding

[Pinelli_7]

Thanx man ill give it a shot. by stack welder do u mean arc?

[Ry_Nos]

Yep thats it. They are a bit hard to start but will never ever break