I just bought my first bike, a zeedee 100cc to learn and play around with. It is a 2003 model, two stroke in decent condition.
I have started having issues. I stalled it and it won't start properly now. I have to kickstart and hold accelerate or the motor will die. It also blows out alot of white smoke, and now dies whenever it feels like.
Check the sparkplug, If it is o.k, try the carby. Will only be a spark or fuel problem. Dont attempt to pull the carby apart unless you got some1 who knows what they are doing with you. I think it is your plug. Maybe your fuel/oil mixture is a bit off. Good luck
Plugs? as in electrical plugs? I hope its not 2 sparkplugs leading to nowhere. ( china has really lost it if there is).Jokes. unscrew sparkplug and check for oil/carbon build-up. May need to clear the gap on the bottom of the plug.
OH and what do you mean u just poured two stroke in? You need to ratio the fuel to oil. If you bought pre-mix from a servo then this is usually for boat motors. you may need to check out what ratio is needed.
I run my CR250 on 30:1 but this may not suit your bike.
Last edited by pickaninny : 29-09-2007 at 10:51 PM.
Check this out it might help. Start lean(less oil)maybe 25mls oil to one litre fuel. It may help with smoke. Rubber Plugs may be for headlight or taillight etc...Wouldnt worry too much bout these
Link to ratios. Hope this helps.2 Stroke Fuel-Oil Ratios
Last edited by pickaninny : 29-09-2007 at 11:05 PM.
Plugs i was tlaking about are just little clear rubber tubes. One end was connected to somewhere till i pulled it out. I doubt they are for lights as I don't have any.