twin carb setup using pocket bike carbs???

[V8_mate]

would it be possible to use two 13mm pocket bike carbs on a custom manifold on a chinese 125? would it even help performance? i remember reading somewhere anout dual stage twin turbos where one is for low rpm performance and the other gives it heaps of top end. i was thinking of doing something similar but with carbs?
any ideas?

[mjc85]

Doubt it'd help performance at all and doubt its worth the effort.

[V8_mate]

i didn't think so either

[cranga]

There are carbies like these on cars, using a primary and secondary intake. Where vacume pressure opens up the secondary intake at higher revs. There was twin carb setups for the little 125's on ebay also. If yo use the search button.

[RKhater32]

check EBAY, they are on there occasionally. dont think you would get any performance gains with it, unless you set it up like a car - where one carb would be primary and the other secondary.

[mjc85]

But those are twin mikunis, that is an overkill for a 125cc motor.

[V8_mate]

i don't think i'll bother, sounds like more trouble than it's worth.
maybe if i find some way of supercharging

[Mack]

IMO The only benefits of a twin setup would come from, like you said, if it had forced induction. This allows much greater fuel/air supply without fitting monster sized carbs. In many bike applications space above the carbs is limited so, two smaller carbs would be used. But, on a naturally aspirated, single cylinder 4 banger, you would upset the intake pressure wave and tuning by departing from a single manifold and carb. Same as you will if you split the exhaust into two pipes, unless of course in that case too, you have forced induction and it doesn't matter.