wont idle

[kwikaz]

hi guys nice to talk to you all, ive got a problem with my idle on my bike its got a walbro carb and for some reason i cant get the thing to keep any sort of idle?? ive played around with the idle screw but it dosnt respond at all the only way i can keep the bike from stalling is holding the throttle on abit?? if anyone can help me out there i would much appriciate thanks guys

[RD RACING]

set the low needle to 1 1/2 turns out from the full in position, set the high needle to 1 full turn out from the full in position. start the engine and then adjust the low needle until the engine idles as low as possible, now adjust the high needle to obtain maximum revs then back off 1/16 th of a turn.

[matty06]

im having the same problem with my bike

[sik-pj]

mixture bolt on the side of ya carby

[kwikaz]

where could i find the hi speed needle???

[RD RACING]

i may have jumped the gun here in regards to your question about [ wont idle ] you mentioned you have a walbro carby, i naturally thought it was a wt type that has both high and low end needle screws but you may have the wyk type. so what carby do you have ?

[kwikaz]

its one of them delorto type carbies , like its gravity feed typr if ya know what i mean?? its got a bowl at the bottom of it i can see two screws but one has a spring on it and the one to the left of it is screwed right in?? so hope that explains it thanks for the help so far

[fiddy_110]

u need a longer throttle cable

[kwikaz]

why do i need a longer cable m8???

[mxmad]

ignore him
(no offence mate)